Reznor RBL Option - Installation - 30% Inlet Air Hood Assembly - Manual

Mfg No. 131794, Page 1
APPLIES TO: Models RGB, RPB, RGBL and RPBL and
Blower Cabinets RBA, RBL with Air
Inlet Options AR6 and AR7
HOOD FOR AIR INLET
OPTIONS WITH 30%
OPENING
INSTALLATION FORM RZ-NA-I-OPT-H
OBSOLETES FORM RZ-NA 400H
Description/Application
The outside air hood included in the air inlet options that have a 30% outside air opening (Options AR6 and AR7) is shipped separately for field
installation. The hood is factory assembled but must be attached to the blower cabinet.
Installation Instructions
On the air inlet side of the blower cabinet, remove the row of factory-installed screws attaching the blower cabinet top. Slide the air hood under-
neath the lip of the blower cabinet top and the sides into the vertical slots. The air hood flange must be between the blower cabinet top and the
cabinet end panel. Reinsert all of the sheetmetal screws.
Figure 1 - Installation of
Screened Air Hood on
Cabinets with 30%
Outside Air Opening
(800) 695-1901 www.RezSpec.com
©20
14 Reznor, LLC. All rights reserved.
Printed in the U.S.A.
MANUFACTURER OF GAS, OIL, ELECTRIC HEATING AND VENTILATING SYSTEMS
Trademark Note: Reznor
® is registered in the United States and other countries.
0
514 OG POD Form I-OPT-H (Version 0.1)
Screened Air Hood for 30% Outside Air Opening
RGB/RPB RGBL/RPBL P/N Width of Hood
75, 100, 125 105117 28-5/8” (727mm)
150 175 105118 34-1/8” (867mm)
200, 225 105119 39-5/8” (1006mm)
250, 300 500, 600 105120 47-7/8” (1216mm)
350 700,1050 105121 53-3/8” (1356mm)
400 400, 800, 1200 105122 58-7/8” (1495mm)
RBA Blower Cabinet 105118 34-1/8” (867mm)
RBL Blower Cabinet 105122 58-7/8” (1495mm)
Remove two corner and
complete row of screws. Blower Cabinet
Air Hood
Vertical Slots -
Slide the side
flanges into the slots.
Slide top flange
underneath cabinet top.
®