Reznor EBHB Option - Installation - Thermostat Kit - Manual

INS412-201305-01
C
o
nç
u et im
p
rimé a
u
C
anada / D
esigned a
n
d p
rin
te
d in C
anada
Built-in thermostat kit for baseboard heater
Trousse de thermostat intégré
pour plinthe électrique
Eq uipo del thermostato montado
en la placa base del c alentador
THE INSTALLATION MUST BE EXECUTED BY A
QUALIFIED TECHNICIAN
RISK OF ELECTROCUTION
INSTALLATION INSTRUCTIONS
Built-in thermostat kit for baseboard heater
CAUTION
DISCONNECT ALL POWER SUPPLIES BEFORE
WORKING ON ANY CIRCUIT
CAUTION:
The thermostat should not be considered an infallible device in cases
where maintaining a temperature is considered critical.
Examples: Hazardous material storage, computer server room, etc. In
these particular cases, it is imperative to add a monitoring system to
avoid the consequences of a thermostat failure.
INSTALLATION:
NOTE: Installation on the left end or the right end.
1. To avoid possible electrical shock, disconnect all power
at main panel prior to wiring.
2. Remove the junction box cover by removing the screw.
Keep the screw for step 5.
3. Screw the assembly thermostat/support on the embossment,
at the bottom of the junction box, using the screw supplied.
4. Make the electrical connections as per the wiring diagram provided
on the other side.
5. Install and screw the new junction box cover provided.
6. Install the thermostat knob.
7. Check thermostat by temporarily setting it at maximum temperature
then at minimum.
8. Adjust the thermostat at the desired setpoint and install the plug
button in the hole for the tamperproof model.
DRAWING AND WIRING DIAGRAM
ON THE OTHER SIDE.