Reznor P6SD Option - Installation - Filter - Lt Commercial - Manual

STEP 1:
Check for correct number of parts. See list below.
1 - Filter Rack
6 - Filters (2 of each size)
4 - #10 x 16 x ½ Type A Screws
STEP 2:
Remove unit return access panel. Retain screws for later use.
STEP 3:
Insert filter rack in unit in front of coil, then expand the rack so it is resting on the bottom of unit and touching the top of unit.
Using screws provided secure filter rack to proper height in front and back. Now install filters in rack see the chart above.
STEP 4:
Put in place and secure return access panel that was removed in Step 2.
Recognize this symbol as an indication of Important Safety Information!
WARNING:
Disconnect electrical power to the unit. Failure to do so can cause electrical shock resulting in personal injury or
death.
INSTALLATION
INSTRUCTION
789A-0399
RETURN ACCESS PANELS REMOVED
FILTER RACK
FILTERS
FILTER RACK
SECURING HOLES
UNIT SIZE FIL TER SIZE
R4GA 024- 042
R4GC 024
P4SA 036
P4SA 048
P4SC 036
Q4SA 036
(2) 14” x 25” x 1”
R4GA 048- 060
R4GC 030- 042
P4SA 060
P4SC 048- 060
Q4SA 048- 060
Q4SC 036
(2) 16” x 25” x 1”
R4GC 048- 060
R4GM 024-072
Q4SC 048- 060
(2) 18” x 25” x 1”
MARCH 21, 2003 NEIFR06B
SUPERCEDES 03-30-99
INSTALLATION INSTRUCTIONS
FOR 547885 FILTER RACK USED WITH
R4GA/GC 024-060 R4GM 024-072
P4SA/SC Q4SA/SC 036-060 UNITS