Reznor R6GF Option - Installation - Filter Kit - Light Commercial - Manual

STEP 1:
Check for correct number of parts. See list below.
1 - Filter Rack
2 - Filters (2 of each size see table)
1 - Return Access Panels
10 - #10 x 16 x ½ Type A Screws
STEP 2:
Remove unit return access panel. Retain screws for later use.
STEP 3:
Insert filter rack in unit in front of coil, then expand the rack so it is resting on the bottom of unit and touching the top of unit.
Using screws provided secure filter rack to proper height in front and back. Now install filters in rack, see chart on back
page.
Recognize this symbol as an indication of Important Safety Information!
WARNING:
Disconnect electrical power to the unit. Failure to do so can cause electrical shock resulting in personal injury or
death.
INSTALLATION
INSTRUCTION
INSTALLATION INSTRUCTIONS
FOR FILTER RACK USED WITH
R4GA/GC 024-060 R4GM 024-072
P4SA/SC Q4SA/SC 036-060 UNITS
603A-0298
A
22
30 23
32
30 15
16
10 5
8
RETURN ACCESS PANELS
FILTER RACK
FILTERS
FILTER ACCESS PANELS
RE TURN AC CESS PANELS
PART A FIL TER SIZE
547887 30 23
32
(2) 14” x 25” x 1”
547888 34 23
32
(2) 16” x 25” x 1”
547889 38 23
32
(2) 18” x 25” x 1”
FILTER RACK
SECURING HOLES
RETURN ACCESS PANEL REMOVED
547886 RETURN
ACCESS PANEL