Reznor R6GP Option - Installation - Roof Curb - Lt Commercial - Manual

This Roof Curb is NRCA approved and is constructed of 18 gauge galvanized steel with a full perimeter 2" x 4" wood nailer
strip. The curb is designed to be used with the Cooling, Gas Electric, and Heat Pump Models. The curb is shipped with the
following parts, (see figure 2):
Step 2:
Layout the curb pieces before assembly to insure that all the necessary pieces are included.
Step 1:
Curb Package is shown as shipped with easy to identify part numbers on all sides. Cut shipping bands and remove
Hardware, Gasket Material, and 4 Duct Supports.
(B)
(E)
(C)
(C)
(A)
(B) (A)
1) 2 ea. Curb Short Sides - 50 7
8
" Long (A)
2) 2 ea. Curb Long Sides - 94 7
8
" Long (B)
3) 2 ea. Vertical Duct Support - 46 7
8
" Long (C)
4) 1 ea. Horizontal Duct Support - 21 ½" Long (D)
5) 1 ea. Horizontal Duct Support - 33" Long (E)
6) 1 ea. Hardware Package Includes:
4 ea. "Hinge" Pins 3
16
"
8 ea. Hex Washers screws #10 x ½"
7) 3 ea. Gasket ¾" x 1 ¼" x 14' (42 ft. total)
U.S. PATENT 5148647
FORM# 606A-1210 (606A-0808)
(D)
INSTALLATION INSTRUCTIONS FOR
547860 / 547861 / 547862 / 547863
ROOF CURBS USED WITH Q5SN/Q6SP 090-120
R6GP/P6SP 072-120 / GR4GN/GP4SN 090-120 UNITS
INSTALLATION
INSTRUCTIONS
Fig ure 1
Fig ure 2