Reznor R6GF Option - Installation - Horiz. Economizer - Light Commercial - Manual

547841 Economizer is used for automatic sensor-controlled introduction of outdoor air into the system through an
electro-mechanically controlled damper.
Step 2:
Take the economizer plug and attach to the unit economizer plug located inside the return air section above the duct
opening. (Factory jumper plug must first be removed.)
Step 3:
Slide Economizer over horizontal return opening of the unit. Secure Economizer using the screws that where provided.
Recognize this symbol as an indication of Important Safety Information!
WARNING:
Disconnect electrical power to the unit. Failure to do so can cause electrical shock resulting in personal injury or
death.
INSTALLATION
INSTRUCTION
FORM# 599A-0808 (599A-0298)
RETURN ACCESS PANEL
ECONOMIZER WIRE HARNESS ROUTING
ELECTRICAL ACCESS PANEL
ADAPTOR PANEL
BAROMETRIC RELIEF HOOD
FRESH AIR HOOD
CONTROL AND FILTER ACCESS
INSTALLATION INSTRUCTIONS FOR
547841
ECONOMIZERS USED WITH R4GM 072
P6SD, Q6SD, R6GD 024-060 UNITS
Step 1:
Check for correct number of parts. See list below.
1 - Economizer Assembly w/ Filter
1 - Adaptor Panels (Attached to Economizer)
1 - Wiring Diagram Sticker
1 - Barometric Relief Hood
1 - Mixed Air Sensor (MAS)
1 - Wire Tie
2 - #10 x 16 x ½” Self-Tapping Screws
10 - #10 x 16 x ½” Type A Screws
RETURN DUCT OPENING
24 12