Reznor R6GP Option - Installatin - Outside Air Damper - Light Commercial User Manual
Installation instruction
I - SHIP PING AND PACK ING LIST
Package 1 of 1 contains:
547864 / 547874
1 - OAD Panel with Slide Damper
1 - Control and Filter Access Panel
1 - Fresh Air Hood with Filter
2 - Snap Clips (304260)
38 - Screws 10 x ½ x 16 Hex Tex
547865
1 - Damper Section with Motor
Check contents for shipping damage. Contact the last carrier
immediately if any shipping damage is found.
II - AP PLI CA TION
The Outside Air Dampers (OAD) are designed to fit the Return
Access Panel. The manual dampers are adjusted by a slide
damper and motorized dampers use a 2-position motor that
opens when blower is energized.
III - IN STAL LA TION - MAN UAL (547864 / 547874)
1.
Remove unit return access panel.
2.
Install OAD panel where return panel was removed. Add
clip to each side near top of panel using existing screw
from unit post.
3.
Assemble fresh air hood. See Figure 1.
4.
Install filter access panel and secure to unit. See Figure 2.
5.
Adjust slide damper to desired position.
IV - IN STAL LA TION - MO TOR IZED (547865)
1.
Remove OAD panel from unit or box depending on new or
retro fitting existing unit.
2.
Remove ½" screws located in clearance holes of hood on
OAD panel. See Figure 3.
3.
Take 1" screws shipped with damper and start in holes
where screws in Step 2 were removed.
4.
Place damper section to engage 1" screws in flange of
damper. See Figure 3.
5.
Place OAD Panel in same place unit panel was located.
Connect (P1) plug from OAD to (S1) plug in unit located in
economizer control panel above filter system.
INSTALLATION
INSTRUCTION
Outside Air Damper (Manual & Motorized)
Manual Damper 547864 used with R6GP & P6SP 072 & 090
Manual Damper 547874 used with Q6SP 090 & 120, P6SP & R6GP 120
Motorized Damper 547865 used with all P6SP, R6GP, Q6SP
UNIT POST
LO CA TION OF CLIPS (STEP 2)
Figure 1
Figure 2
Figure 3
CONTROL MOTOR
HOOD OUTLINE
DAMPER FLANGE
MANUAL SLIDE DAMPER
OAD PANEL
FORM# 607A-0611 (607A-0808)
CON TROL & FIL TER
AC CESS PANEL
FRESH AIR HOOD
21
15
14 ¾
RETURN ACCESS
REMOVED
CON TROL & FIL TER AC CESS PANEL
OAD PANEL
HOOD FILTER ACCESS
REMOVE SCREW IN
½" HOLES