Reznor Q6SD Option - Installation - Power Exhaust - Lt Commercial - Manual

INSTALLATION
INSTRUCTION
INSTALLATION INSTRUCTIONS FOR
547842 / 555578 / 555579 / 547843 / 555580 / 555581 / 555651
POWER EXHAUST USED WITH R4GM 072
P6SD, Q6SD, R6GD 024-060 UNITS
FIG URE 1
END SWITCH KIT
FIGURE 2
FORM# 836B-0808 (836B-1104)
I - SHIP PING AND PACK ING LIST
Package 1 of 1 contains:
1 - Power Exhaust Assembly
1 - Fresh Air Hood
8 - #10 x ½ x 16 Hex Tec
1 - End Switch Kit
Check contents for shipping damage. Contact the
last carrier immediately if any shipping damage is
found.
II - AP PLI CA TION
The power exhaust is designed to relief excess
pressure that may occur with economizers or
building conditions.
III - IN STAL LA TION
1. Disconnect all power to unit.
2. Cut and discard wire tie securing wire bundle for high voltage connection.
Important - DO NOT cut other wires. Inspect for damaged connections or loose wires.
3. Remove barometric relief hood and fresh air hood of the economizer or if installing along with economizer omit this
step. See Figure 4.
EXHAUST HOOD
CONTROL ACCESS
EXHAUST MOTOR & FAN
NEW FRESH AIR HOOD
ECONOMIZER INSTALLED
DOWN FLOW APPLICATION
FRESH AIR HOOD
BAROMETRIC RELIEF HOOD