Creda CM 311 I - Manual (Page 7)

Mounting the appliance
7
Before mounting the appliance into the
kitchen uniut, disconnect the power supply
and set the thermostat knob to the OFF (O)
position.
Push the appliance for some 38mm into the
kitchen unit and allow at least 4mm free
space on both sides between the appliance
and the side walls of the kitchen unit. (Fig.1)
Open both doors as wide as possible and put
them together with the door of the kitchen
unit. The proceduere is as follows;
*
Fix the slide guides (attached in a plastic
bag along with the screws ST 4,2 x 9,5) to
the edge of the door. Cover the open
holes with the attached cap.
* Put the appliance door and the door of
the kitchen unit (Fig.2).
Insert the slides into the guides and fix
them on the kitchen unit door some
15mm from the edge, using the A4 x 12
screws (Fig.3).
* Remove the slide guides and separate the
appliance door from the door of the
kitchen unit.
* Fix the slides taking care not to move
them (Fig.4).
* Fix the slides to the original position.
* Close the door and check that the gasket
is not creased and the door opens
smoothly
Fig.1
Fig.3
Fig.4
Fig.2
694527.qxd 1/31/03 9:18 Page 7