Ryvyr L-BAMBU-36-10DB - Manual

INSTALLATION INSTRUCTIONS
LEGS
L-BAMBU-30-XX | L-BAMBU-36-XX
SUGGESTED TOOLS AND MATERIALS
Phillips Screwdriver Level Drill Tape Measure Safety Glasses
10'
INSTALLATION INSTRUCTIONS
• Using the hex wrench provided, attach the base of the vanity to the bottom of the vanity.
• Position the vanity against the finished wall. If necessary, turn the leg levelers to achieve proper level.
• Mark the supply and drain locations on the inside of the vanity back wall.
• Move the vanity away from the wall and cut the marked supply and drain locations from inside.
• Install the counter top, sink, drain and faucet according to the manufacturer’s instructions.
CARE AND CLEANING
• To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme
changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing
furniture directly under windows.
• Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish it on a regular basis. Clean the surface by rubbing
in the direction of the grain. Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of time will
cause white spots in the finish. Please note that some chemicals may damage the finish.
10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time
BAMBU
TM
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don’t
hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage.
The appearance of your vanity may differ from the illustrations in this guide. These instructions still apply. Please ensure that the
finished wall is straight and plumb and the floor is flat and perpendicular to the finished wall.
L-BAMBU-30-6DB
L-BAMBU-36-6DB
L-BAMBU-30-10DB
L-BAMBU-36-10DB