Ryvyr VC-MALAGO-20DM - Manual

11.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time
INSTALLATION INSTRUCTIONS
MALAGO
CORNER VANITY
VC-MALAGO-20DM
TM
SUGGESTED TOOLS AND MATERIALS
Phillips Screwdriver Level Drill Jigsaw Tape Measure Safety Glasses
10'
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you
encounter any installation problems, please don’t hesitate to contact us. Before you begin,
please observe all local building codes. Unpack the new product and inspect for damage.
The appearance of your vanity may differ from the illustrations in this guide. These
instructions still apply. Please ensure the finished wall is straight and plumb and the floor
is flat and perpendicular to the finished wall.
INSTALLATION INSTRUCTIONS
• Position the vanity against the finished walls.
• Mark the supply and drain locations on the inside of the vanity back wall.
• Move the vanity away from the wall and cut the marked supply and drain locations from inside.
• Position the vanity against the wall, aligning the supply and drain locations with the cut holes.
• Install the countertop, sink, drain and faucet according to the manufacturer’s instructions.
CARE AND CLEANING
For best results, keep the following in mind when caring for your Ryvyr product:
• To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also
avoid extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air
conditioning units. Avoid placing furniture directly under windows.
• Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish it on a regular basis. Clean the
surface by rubbing in the direction of the grain. Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period
of time will cause white spots in the finish. Please note that some chemicals may damage the finish.
• Clean the mirror using a soft, slightly damp cloth. When cleaning the mirror, spray the mirror with a glass cleaner
and wipe clean.
WALL
FLOOR
ROUGHING-IN
** NOTE: vanity style, shape, and cutout
on top may vary from the picture above.
Instructional purposes only.