Ryvyr UM100XX - Manual

INSTALLATION INSTRUCTIONS
DRAINS
ALL MODELS
THANK YOU FOR CHOOSING
RYVYR
Please take a few minutes to review this manual before you start installation. If you encounter
any installation problems, please don’t hesitate to contact us. Before you begin, please observe
all local building codes. Unpack the new product and inspect for damage. The appearance of
your drain may differ from the illustrations in this guide. This instructions still apply. Please
ensure the finished wall is straight and plumb and the floor is flat and perpendicular to the
finished wall.
SUGGESTED TOOLS AND MATERIALS
Adjustable Wrench Channel Lock Tape Measure Safety Glasses
10'
CARE INSTRUCTIONS
To keep your drain looking new, please follow these simple care instructions
DO:
Simply rinse the drain clean with clean water and mild soap
Dry the drain with a soft cotton cloth
DON'T: Do not use any abrasive cleaners, cloths or paper towels.
Do not use any cleaning agents containing acids, polish abrasives or harsh cleaner or soap
Regular and routine cleaning will reduce the need for heavy cleaning and polishing.
STEP 2
Slide (a) rubber gasket to the top of drain body as shown.
STEP 1
Unscrew drain body from tail peice
Place mounting ring in the center of vessel top where it will align with cutout.
STEP 3
Install drain body through sink.
From under countertop, screw on tail peice to drain body.
STEP 4
STEP 5
Slide (b) rubber mac washer to the drain body. Then screw (c) retaining nut to
the drain body.
STEP 6
Tighten the drain assembly lock nut by hand until it stops turning, making sure
that all silicone gaskets are used and in their proper places. Then turn the lock
nut half turn with a wrench for final tightening.
It may be necessary to cut part of the tail-piece or part of the horizontal leg
** NOTE: drain style and sink may
vary from the picture above.
Instructional purposes only.
in order to make fit to existing plumbing.
CAUTION! Do not overtighten drain assembly as this
may cause bowl to forcefully crack during installation
or at some time in future.
drain body
(a) rubber gasket
(b) rubber mac
washer
(c) retaining nut
mounting ring
tail peice
For customer support please call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time