Ryvyr M-WAVE-24DE - Manual

08.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time
INSTALLATION INSTRUCTIONS
WARWICK
MIRROR
M-WARWICK-XXXX
TM
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you encounter
any installation problems, please don’t hesitate to contact us. Before you begin, please
observe all local building codes. Unpack the new product and inspect for damage. The
appearance of your vanity may differ from the illustrations in this guide. These instructions
still apply. Please ensure the finished wall is straight and plumb and the floor is flat and
perpendicular to the finished wall.
SUGGESTED TOOLS AND MATERIALS
Phillips Screwdriver Level Drill Tape Measure Safety Glasses
10'
1
MIRROR INSTALLATION
2
CARE AND CLEANING
• To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme
changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing
furniture directly under windows. Damage caused by any of the afore mentioned will void the warranty.
• Clean the mirror using a soft, slightly damp cloth or a soft cloth with glass cleaner. Avoid using silicone cleaners and waxes.
• Clean the furniture frequently with a clean, soft, dry, lint-free cloth. Clean the surface by gently rubbing in the direction of the grain.
Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping action. Water left over a long period of time will
cause white spots in the finish and the furniture to possibly warp. Please note that some chemicals may damage the finish.
Standing water and the use of strong chemicals will void the warranty.
NOTE: Where possible, try to affix a stud or provide adequate wall support for the size and weight of the mirror. Mirror comes with
pre-attached brackets on the frame and a wall mount rail. Affix the rail to the wall in the desired location by pre-drilling the rail and
then affixing the rail using the proper fastening, based upon wall material.
MIRROR INSTALLATION
Finished Wall