Samson Super Juicer 08-5000 - Manual (Page 6)

-7- -6-
Figure 5
Head
Locking
Screw
ASSEMBLY INSTRUCTIONS
1. Slide the Screen (curved side
down) into the slot on the inside bottom
of the Head until it stops. Make sure
both sides of the Screen are within the
slot (Figure 2).
2. Place the Auger Bearing onto the
splined end of the Auger. Insert the the
Auger into the open end
of the Head until it stops.
The splines on the end of
the Auger should protrude
from the opposite end of the
Head (Figure 3).
3. Place the
Rubber
Gasket onto the flat surface
on the inside of the Head
Aligning Cap below the
threads. The Rubber
Gasket is properly installed
when it lays flat on the
surface (Figure 4).
4. Screw the Head Aligning Cap
counterclockwise onto the Head until it
is firmly seated.
5. Screw the Waste Valve
counterclockwise into the tip of the
Head Aligning Cap until it stops.
7. Loosen the
Head Locking Screw
on the Juicer Motor until it no longer
protrudes into the receptacle for the
Head Assembly (Figure 4).
8. Install the
Head Assembly onto the
Juicer Motor. You will need to align the
cutout on the Head with the pin inside
Figure 2
Figure 3
Slot
WARNING!
Before cleaning, assembling or disassembling the
Wheatgrass Juicer, make sure it is turned “OFF” and the Power Cord is
disconnected from the electrical outlet.
Head
Screen
Head
Auger
Bearing
Auger
Rubber
Gasket
Head
Aligning
Cap
Waste
Valve
Auger
Splines
Figure 4
CAUTION:
Make sure Screen
is properly seated
in the slot before
operation or unit
damage will occur.
Pin Inside
Receptacle
Cutout
In Head
5. After washing, drain the sink and refill it with warm water.
6. Rinse the parts by submerging them in water. Change the water and repeat, if necessary, to
remove all of the detergent.
7. When done rinsing, drain the sink and refill it with a sanitizing solution of water and chlorine
bleach (use 1 ounce of chlorine bleach per 4 gallons of water). Soak the parts in the solution for
a minimum of 5 minutes.
8. Remove the parts from the sink.
9. Allow the parts to air-dry before reassembling and storing the
Wheatgrass Juicer.
NOTE! The Wheatgrass Juicer is NOT dishwasher safe.
the receptacle (Figure 5). Align the
Auger Splines with the keyways
on the drive shaft of the Juicer
Motor. If the parts do not align,
rotate the Auger end (it protrudes
from the Head) a bit and try again.
Wiggling the Head Assembly
during installation may help as well.
IMPORTANT: Tighten the Head
Locking Screw until it firmly holds
the Head Assembly in place.
CAUTION!: DO NOT operate the
Wheatgrass Juicer without the
Head Assembly firmly secured
into place. Personal injury or unit
damage may occur.
NEVER operate Wheatgrass Juicer unless it is
fully and properly assembled.
To avoid serious or fatal injury, NEVER reach into any inlet or outlet.
ONLY USE the Stomper to push wheatgrass into the Head.
Read and understand all information in this manual before use.
WARNING!