Sandia Aerospace AIS200A-35 - Manual (Page 6)

SECTION 3
INSTALLATION PROCEDURES
3.1 General
The AIS 200-35 and AIS 200A-35 is supplied with a 78 pin Sub D mounting connector and 80 crimp
style contacts. The AIS 200-35 and AIS 200A-35 is hard mounted in any axis using four (4) number 6
or 8 screws.
3.2 Equipment Required
3.2.1 Supplied
Model AIS 200-35, Sandia Part Number AIS 200-35 or Model AIS 200A-35, Sandia Part Number
306119-00
Electrical Installation Kit Sandia Part Number 305552-00. The installer may also use the manufac-
tures part in lieu of the Sandia Part. The Manufacturer and their part number is listed below along
with the Sandia Part Numbers.
1 each 204508-1 Connector Housing (AMP/TYCO P/N 204508-1)
1 each 305055 Connector Clamp (AMP/TYCO 1-5207908-3)
80 each 305070 Crimp Contacts (AMP/TYCO P/N 204351-1)
3.2.2 Required But Not Supplied
Four (4) Number 6 or Number 8 or equivalent mounting screws.
3.3 Mounting
The AIS 200-35 and AIS 200A-35 mount with four (4) Number 6, 8 or equivalent machine screws in the
four holes in the units mounting fl anges.
Figure 3-1
Mounting Dimensions
3 306147 Rev A