Sandia Aerospace SAE 5-35 Installation Manual - Manual (Page 9)

3.1 GENERAL
The SAE5-35 is supplied with a mounting tray and solder type mating connectors. It is important
that proper solder techniques be observed in attaching wires to the mating connectors. Failure to do
so could result in a failure in the connection and cause intermittent or non operation of the SAE5-35.
Section 3 Installation Procedures
3.2 EQUIPMENT REQUIRED
3.2.1 Supplied
SAE5-35 System 705154-00
Includes: SAE5-35 Encoder 305154-00
SAE5-35 Installation Manual 305186-00
SAE5-35 Installation Kit 305216-00
15 Pin Mating Connector 305215
15 Pin Connector Hood 305208
9 Pin Mating Connector 305214
9 Pin Connector Hood 305207
Mounting Tray 305145
Knurled Holdown Nut 305189
3.2.2 Required but not supplied
Number 6-32 mounting screws
Static port fitting
3.2.3 Optional Equipment
AIM Annunciator, Installer supplied or Sandia Part Number 307217-00
3.3 MOUNTING TRAY INSTALLATION
The mounting tray is mounted to the airframe using either three or four number 6-32 screws. The
mounting hole pattern for the SAE5-35 mounting tray contains five holes. For new installations, it is
recommended that the four corner holes be used to mount the SAE5-35 tray. The fifth hole has been
added to facilitate upgrades from other manufactures encoders. Refer to the SAE5-35 tray dimen-
sions in Figure 3-1 to determine if the hole pattern of the removed system match the hole pattern of
the SAE5-35 mounting tray.
8 305186-00