Santec 1155TT - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
AFTER FLUSHING, SHUT OFF BOTH SUPPLY LINES
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4 ” AND MAXIMUM IS 1 1/2 ”
SPOUT INSTALLATION
1
- Remove the Quick Connect Spout Shank and Mounting Hardware from the box.
Remove the mounting hardware (metal washer and brass lock nut) from the Quick Connect
Shank.
- From the top of the deck, slip the quick Connect shank with the brass plate through the
assigned spout hole.
- Secure the quick connect shank by putting the washer and locknut back on the shank.
Tighten the lock nut firmly.
2.
- Remove the faucet from the box.
- From the top of the deck, slip the spout (1) with the flange(3) onto the quick connect shank
top. Align the spout and tighten the set screw with the Large Allen Key (21) provided.
3
- Connect the spout shank to one of the outlet port (OUT) of the diverter valve after the diverter
valve is installed. **
Note: for better installation it is advisable to place silicone caulking around all holes on the top
of the deck
If the trim is ordered separately, please keep the shank protector on the quick connect shank
at all time to avoid damages to the unit.
HANDLE INSTALLATION
1.
- Using the medium Allen Key provided, loosen the handle set screw
- Unscrew the pre-assembled handle trim (2)and the top mounting hardware from the
valve body.
- Slip the valve body (8) or (9) up from the bottom of the tub through the appropriate hole next
to the spout.
- From tub top, insert the top mounting hardware back onto the valve. Do not tighten.
screw the handle bell of the handle trim (2) back onto the valve body. After the height of the
handle bell is set, unscrew the handle bell and tighten the mounting hardware firmly. Reinsert
the handle bell and screw it tight against the valve’s cartridge thread.
- Insert the handle back onto the valve stem and tighten the set screw using the medium Allen Key.
Make sure that the handles turns freely in both directions.
2
- Position the valve body side outlet towards the diverter valve (12) for easier pipe connection.
Align the handle lever and tighten lock nut (5) firmly. Repeat the same procedure for the
opposite side.
- Connect the water supply lines to the bottom inlets of the valve bodies. **
- Connect the valve body side outlet to the inlet (IN) of the diverter valve (12) after the diverter
is installed. **
PAGE 02
1155TT _ _
Fiber washer
Brass lock nut
Handle Bell
Handle
Medium Allen Key
Fiber washer
Brass lock nut
Metal washer
Brass lock nut
Metal washer
Brass lock nut
Brass plate
Large Allen Key