Santec 1332CA - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate onto the all thread.
- Screw the handle bell with the flange onto the all thread.
Make sure that both parts are firmly flushed against the plate and
mark the position.
Remove the flange and handle bell and cut off the excess thread.
Reinsert the flange and handle bell onto the all thread.
- Insert the handle onto the stem. Measure the excess between
the handle bell and the handle. Take off the handle and cut the
excess stem.
- Reinsert the handle onto the stem. Using the Allen key provided,
Tighten the handle set screw firmly.
INSTALLATION INSTRUCTIONS
All Thread
Lock Nut
Lock Plate
Trim Plate
Stem
PAGE 03
COLD
WARM
WARMER
HOT
ILLUSTRATION C
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN
C C H H C C H H
1332CA _ _
HANDLE BELL HANDLE HANDLE FLANGE