Cisco 7921G - Manual (Page 6)

Chapter 3 Setting Up the Cisco Unified Wireless IP Phone 7921G
Before You Begin
3-6
Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified CallManager Release 4.1, 4.2, 5.0
OL-10802-02
Note When using BAT to add Cisco Unified Wireless IP Phones, use the default setting
for the phone load. The phone load name includes symbols (-, _,.) and BAT does
not permit symbols in an entry.
Related Topics
• Adding Phones with Auto-Registration, page 3-4
• Adding Phones with Auto-Registration and TAPS, page 3-4
• Adding Phones with Cisco Unified CallManager Administration, page 3-6
Adding Phones with Cisco Unified CallManager Administration
You can add phones individually to the Cisco Unified CallManager database
using Cisco Unified CallManager Administration. To do so, you first must obtain
the MAC address for each phone. See the
“Methods for Adding Phones to Cisco
Unified CallManager” section on page 3-3 for instructions.
After you have collected MAC addresses, choose Device > Add a New Device in
Cisco Unified CallManager Administration to begin.
For additional instructions and conceptual information about
Cisco Unified CallManager, refer to Cisco Unified CallManager Administration
Guide and to Cisco Unified CallManager System Guide.
Related Topics
• Adding Phones with Auto-Registration, page 3-4
• Adding Phones with Auto-Registration and TAPS, page 3-4
• Adding Phones with BAT, page 3-5
Safety Information
Review the following warnings before installing the Cisco Unified IP Phone. To
see translations of these warnings, refer to the
Regulatory Compliance and Safety
Information for the Cisco Unified Wireless IP Phone 7921G and Peripheral
Devices
document that accompanied this device.