Clarion UNGO PRO SECURITY SYSTEM K20 User Manual
Page 10
7
© 2 0 0 6 d i r e c t e d e l e c t r o n i c s , i n c .
unlocking/disarming
Pressing
for one second disarms the system and unlocks the
doors (if connected). The horn will honk twice (if connected and
in audible mode) and the parking lights will flash twice to confirm
disarming of the system. The optional Failsafe
®
Starter Kill will be
deactivated. The status LED will turn off, unless the system is pro-
grammed for Passive Mode. In Passive Mode, the status LED will
flash rapidly when the system is disarmed. This indicates that the
system will re-engage the starter kill and re-lock the doors (if
Passive Locking has been programmed) in 30 seconds unless the
ignition is turned on.
disabling the system without a transmitter
If your remote transmitter is lost or damaged, you can manually
override the system. To do this, you must have the vehicle's igni-
tion key and know where the Valet
®
switch is located. Be sure to
check with the installer for the location of the Valet
®
switch.
➜
note: If the system has been armed with the remote trans-
mitter, you must use the transmitter or the Valet switch
to disarm the system and deactivate the starter kill.
Manually unlocking the vehicle does not disarm the sys-
tem; it will only unlock the doors.
➜
note: For Passive Mode to be effective, the Failsafe®
Starter Kill relay must be installed.