Santec 2568XU - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the soap dish off the box.
Place the dish against the assigned wall location.
Mark the dish holder’s flange position and remove the trim.
2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the flange mark on the wall.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware post can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimension carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting hardware post by screwing the screws into
the wall.
3- Using the Allen key provided, loosen the dish holder’s set screw.
Slip the holder with the washer onto the mounting hardware post.
Adjust the holder to make sure the dish is horizontally leveled.
Tighten the set screw after the adjustment.
4- Check the holder to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
05/03
2568XU _ _