Santec 3518ST - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE HANDLE TRIMS IS 1 5/8” AND MAXIMUM OF 1 3/4”
INSTALLATION INSTRUCTION
INSTALLING THE VALVE WITHOUT THE TRIM
1- Insert the rubber washer Pm400 in the groove on the back of the
wall mount spout.
WARNING: Where tile construction is planned for the
finished walls, allow for the extra thickness
dimensions when roughing in the valves.
INSTALLING THE VALVE WITH THE TRIM
1- Install the wall mount assembly onto the wall.
2- Screw in the water inlet pipe in the wall mount assembly.
PAGE 02
3518ST_ _
Water inlet
pipe