Santec 3576TD - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4 ” AND MAXIMUM OF 1 1/2 ”
SPOUT INSTALLATION
1
- Insert the Rubber O rings in to the shank. And put the complete bridge assembly (1)
aligning two holes on the platform center set plate. Put under the platform plate a rubber platform
gasket on the top of the wash basin deck.
Apply a ring of silicon caulking around the center hole on the top of the sink. Do not use
plumbers' putty which can damage the finish of the faucet.
2
- Slip the metal washer (3) back onto the shank. First the rubber washer, then the metal
washer and lastly the brass lock nut. Tighten the lock nut firmly.
- Tighten to seal.
- Align the spout and tighten the shank lock nuts firmly.
HOSE TRIM INSTALLATION
1
- Two inlet and outlet hose are given to connect the hot and cold water inlets.
Put on the hose on the thread shank of the bridge. Screw on the nuts of the
hose upwards on the shank.
- Connect other end of the hose to the supply lines of the water to cold and
hot water lines respectively.
- Tighten the nuts until it secures the shank body firmly.
PAGE 02
3576-TD _ _