Santec 6750AR-TM - Manual

E S T A T E S E R I E S A R K O C O L L E C T I O N
R O M A N T U B F I L L E R T R I M
W I T H “ A R ” H A N D L E S
M O D E L : 6 7 5 0 A R 1 0 - T M
6 7 5 0 A R 7 5 - T M
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
I m p o r t a n t : P l e a s e re g i s t e r y o u r p ro d u c t o n l i n e a t w w w. s a n t e c f a u c e t . c o m w i t h i n
3 0 d a y s o f p u rc h a s e . S a n t e c re s e r v e s t h e r i g h t t o re q u e s t a d d i t i o n a l d o c u m e n t s
b e f o re s e r v i c i n g w a r r a n t y re q u e s t s .
0 1 0 2
Roman Tub Filler Trim
1. Spout Installation
From the top of the deck, insert the spout onto the top of
quick connect shank.
Align the spout and tighten the set screw with the large Allen
key. Insert the spout plug into the spout back hole.
NOTE: For better installation it is advisable to place silicone
caulking around all holes on the top of the deck.
Flush both supply lines before installation. After flushing shut off both supply lines.
Hole size for the spout and handle trim is a minimum of 1¼” and a maximum of 1½”.
Metal Washer
Brass Lock Nut
Brass Lock Nut
Fiber Washer
Upper Lock Nut
Rubber Washer
2. Handle Trim Installation
Screw the handle trim onto the upper lock nut of installed
valve.
Adjust the handle alignment in respect to the spout.
Make sure that the handle turns freely in both direction and
tighten the brass lock nut firmly. If the handle is scraping
against the stem, lower the valve body to reduce the friction.
Repeat the same process for the opposite side handle.