Santec 9255DC - Manual

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
MINIMUM HOLE SIZE FOR THE SPOUT AND
HANDLE TRIM IS 1 ¼ ” AND MAXIMUM OF 1 ½ ”
*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.
BAROQUE & ENZO APPLICATION EDO APPLICATION
¾” N.P.T. SPOUT SHANK QUICK CONNECT SHANK
-Remove tee connector and spout mounting -Remove tee connector and spout
hardware from spout nipple. mounting hardware from quick
-Apply a ring of silicone caulking around connect shank being sure to leave
hole designated for spout . on brass plate.
DO NOT USE PLUMBERS’ PUT TY, WHICH -Apply a ring of silicone caulking
CAN DAMAGE FINISH. around hole designated for s pout.
-Slip spout and spout base throu gh top of DO NOT USE PLUMBERS’ PUTTY,
deck. WHICH CAN DAMAGE FINISH.
-Reattach spout mounting hardware and -Slip quick connect shank through
secure spout. deck top.
-Thread tee connector onto spou t shank. -Reattach spout mounting hardware
until secure.
-Place spout onto quick conn ect
shank and set in place with allen key
and set screw provided.
Large Allen Key
ROMAN TUBS W & W.O. HANDSHOWER INSTALLATION
INSTRUCTIONS FOR DROP IN VALVES