Santec 9555KT-TM - Manual (Page 3)

0 3
S p o u t R o u g h
Rough Installation For Spout
NOTE: Only remove protective cap while installing rough and when
installing the trim. This will keep debris out of moving parts.
Remove protective cap from the head of the shank. DO NOT THROW
AWAY.
Turn off HOT and COLD supply lines before beginning installation.
Unscrew the Lock Nut off of the shank and move down the Spout
Mounting Hardware a few inches (Figure A).
Apply a ring of silicone caulking around deck hole (Figure A). DO
NOT USE PLUMBER’S PUTTY, WHICH CAN DAMAGE FINISH.
Slip the remaining Shank Assembly up and through the deck hole from
underneath. While holding the assembly up and off of the silicone,
thread the lock nut back onto the shank until it bottoms out (Figure A).
NOTE: Find the “front here” mark, which is marked on the base of the
graphic in Figure B).
IMPORTANT: Set the shank down onto the ring of silicone with the
“front here” mark facing frontward. Use a long straight- edge to align
the front of the lock nut parallel with the deck edge. From underneath,
tighten the spout mounting hardware until secure (see Figure B).
Wipe away excess silicone with paper towel.
Fit the protective cap back onto the head of the shank until trim
arrives.
NOTE: Hole size for the spout, handle trim, and hand held shower is
a minimum of 1-1/4” and a maximum of 1-1/2”.
9555KL, KR, KT _ _