ScanTool 2000 ECUsim - Manual (Page 10)

10 ECUsim™ 2000 User Guide
5.0 Software Configuration
On startup or reset, the PIM prints the welcome banner that looks similar to
this:
STS2000 v3.1.5
(C) 2013 OBD Solutions
>
The PIM is now ready to accept user commands.
5.1 Supported Commands
For a list of supported commands, see the ECUsim Programming Manual that
can be found on the ECUsim 2000 product page, at:
http://ecusim.com/2000
6.0 Advanced Operation
This section describes the operation of the simulator in different protocol
modes. It assumes that the simulator is connected to a PC running terminal
emulation software.
6.1 ISO 9141-2 and ISO 14230-4 (5 Baud Init)
After switching to the ISO 9141-2 protocol (or ISO 14230-4 with 5 baud init
option) the simulator will print the following status message:
<WAITING FOR 5 BAUD INIT>
It will not respond to any requests until the bus is initialized. After a successful
initialization sequence, the simulator will print:
<5 BAUD INIT: OK>
At this point, the virtual ECUs will start responding to OBD requests. However,
if five seconds pass without a supported request (or a keep-alive message)
being received, the ECUs will time out and the simulator will go back to
waiting for initialization: