Setting up your monitor, Page12 sceptre x24 – Sceptre X24WG-1080 User Manual

Page 12

Advertising
background image

Page12 SCEPTRE X24

Setting Up Your Monitor

The following are general short steps to setup and use the monitor with your PC under the Microsoft
Windows XP operating system
.

1.

After you have installed the base, connect your VGA or DVI cord to both the monitor and PC and
turn on the PC and the monitor.

2.

While booting up keep pressing F8 and choose the VGA mode option.

3.

Under Windows, use your mouse to right click on the background with nothing selected. Left click
on the PROPERTIES option. Click on the SETTINGS tab.

4.

Under SETTINGS change your resolution to 1920 x 1200 and click on APPLY. (if you are using
DVI as your connection click on OK and you are done, steps 6-10 are unnecessary)

5.

Click on ADVANCED button, and then click on MONITOR tab. Under MONITOR make sure your
refresh rate is set to 60 Hz.

6.

Click on OK on all windows to exit.

7.

On the monitor, press the M button twice in succession to AUTO ADJUST.

8.

Wait until the monitor finishes calibrating. Reboot your computer and your monitor is ready for
use.

9.

[OPTIONAL] Because this monitor’s native resolution is very high, words may seem too small for
some users. Please follow steps 1-5. Afterwards, click on the GENERAL tab. In there you
can change the size of the words by changing from the option from “normal size” to “large size”.
Click on APPLY to finalize this selection. This will make the words bigger under Windows XP.




The following are general short steps to setup and use the monitor with your PC under the Microsoft
Windows VISTA operating system
.

1.

After you have installed the base, connect your VGA or DVI cord to both the monitor and PC and
turn on the PC and the monitor.

2.

While booting up keep pressing F8 and choose the VGA mode option.

3.

Under Windows, use your mouse to right click on the background with nothing selected. Left click
on the PERSONALIZE option. Click on the DISPLAY SETTINGS option.

4.

Change your resolution to 1920 x 1200 and click on APPLY. (if you are using DVI as your
connection click on OK and you are done, steps 6-10 are unnecessary)

5.

Click on ADVANCED SETTINGS button, and then click on MONITOR tab. Under MONITOR
make sure your refresh rate is set to 60 Hz.

6.

Click on OK on all windows to exit.

7.

On the monitor, press the M button twice in succession to AUTO ADJUST.

8.

Wait until the monitor finishes calibrating. Reboot your computer and your monitor is ready for
use.

9.

[OPTIONAL] Because this monitor’s native resolution is very high, words may seem too small for
some users. Under Windows Vista please right click on the background with nothing selected
and select the PERSONALIZE option. Afterwards, click on the ADJUST FONT SIZE (DPI)
option on the left column and click on continue. In there you can change the size of the words by
changing from the option from “default scale” to “large scale”. This will make the words bigger
under Windows XP. Click on APPLY to finalize your selection.


Advertising