SeaLand Vacuum Breaker Kit User Manual

Sealand, Vacuum breaker kit installation

Advertising
background image

1.

Turn off water supply to toilet.

2a. Reach behind toilet. Twist and pull vacuum breaker

from back of toilet bowl. Go to Step 6.

2b. If you are unable to pull vacuum breaker from back

of toilet because toilet bowl is too close to wall,
press flush pedal to drain water from toilet bowl,
then go to Step 3.

3a. For toilets with visible floor bolts, uncover bolts and

remove them. Remove toilet from floor flange. Tilt
or turn toilet away from wall and pull vacuum
breaker from back of toilet. Set toilet aside. Go to
step 5.

3b. For toilet with pedestal cover, remove pedestal cover,

then remove floor bolts. Remove toilet from floor flange.
Tilt or turn toilet away from wall and pull vacuum breaker
from back of toilet. Set toilet aside.

4.

For toilet models 110, 111, 147, 148, 210, 706, 711-M28 and 712-TM09, remove vacuum
breaker cover.

5.

Remove water valve hose (and hand sprayer hose, if applicable) from old vacuum
breaker and install on new vacuum breaker with new hose clamp (supplied). For new
vacuum breaker equipped with hand sprayer outlet, make sure strain-relief bracket is
positioned on water valve connection side of vacuum breaker and hand sprayer hose
(as shown) before connecting water valve hose.

6.

On back of toilet bowl, pull old rubber expansion gasket out. Insert new rubber
expansion gasket.

7.

For toilet models 110, 111, 147, 148, 210, 706, 711-M28, 712-TM09, 3210, 3310, 3410,
4310 and 4410, remove top Disc from new vacuum breaker (if supplied with new
vacuum breaker).

8.

Using soapy water as a lubricant, insert new vacuum breaker into expansion gasket as
far as possible. Reinstall vacuum breaker cover (if applicable).

9a. If you did not remove toilet bowl from base or floor, go to Step 11.
9b. If you removed toilet from floor, reassemble by positioning toilet and floor flange seal

properly onto floor flange and tightening fasteners. NOTE: If floor flange seal is
distorted, replace with new seal.

10. Reinstall pedestal cover (if applicable).
11. Turn on water supply.

Disc

TOILET BOWL (rear view)

Water Valve

Hose Connection

Hand Sprayer

Hose Connection

(not included

with all models)

Strain-Relief

Bracket

(not included

with all models)

Vacuum Breaker

SeaLand

®

Vacuum Breaker Kit Installation

600344418 01 11-11

Dometic Corporation

13128 State Rt 226

PO Box 38
Big Prairie, OH 44611

1-800-321-9886

© Dometic Corporation

Advertising