Cisco 6500 - Manual (Page 70)

4-70
Cisco IOS Software Configuration Guide, Release 12.2SX
OL-13013-06
Chapter 4 Configuring Virtual Switching Systems
Upgrading a VSS
Cat6k-Sup720/RP platform with 1048576 Kbytes of main memory
Download Start
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
(Deleted many lines)
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Download Completed! Booting the image.
Self decompressing the image :
##########################################################################################
(Deleted many lines)
################################################################################ [OK]
running startup....
(Deleted many lines)
000147: Aug 6 16:53:43.199 PST: %HA_CONFIG_SYNC-6-BULK_CFGSYNC_SUCCEED: Bulk Sync
succeeded
Verify the Switchover
You can now enter the show issu state detail command and the show redundancy command to check
that both chassis are in the ISSU Run Version state and SSO redundancy state. In this example, the
active chassis is now running the “newversion” image.
Router# show issu state detail
Slot = 2/7
RP State = Active
ISSU State = Run Version
Boot Variable =
disk0:s72033-newversion.v2,12;disk0:s72033-oldversion.v1,12
Operating Mode = sso
Primary Version = disk0:s72033-newversion.v2
Secondary Version = disk0:s72033-oldversion.v1
Current Version = disk0:s72033-newversion.v2
Variable Store = PrstVbl
Slot = 1/2
RP State = Standby
ISSU State = Run Version
Boot Variable = disk0:s72033-oldversion.v1,12
Operating Mode = sso
Primary Version = disk0:s72033-newversion.v2
Secondary Version = disk0:s72033-oldversion.v1
Current Version = disk0:s72033-oldversion.v1
Router# show redundancy status
my state = 13 -ACTIVE
peer state = 8 -STANDBY HOT
Mode = Duplex
Unit = Primary
Unit ID = 39
Redundancy Mode (Operational) = sso
Redundancy Mode (Configured) = sso
Redundancy State = sso
Maintenance Mode = Disabled
Communications = Up
client count = 134
client_notification_TMR = 30000 milliseconds
keep_alive TMR = 9000 milliseconds