Shellab SGO5-2 - Manual (Page 6)

6
PRECAUTIONS
4.1 The bottom surface of the chamber should not be used as a work surface.
4.2 This unit has been designed with a dampered vent from the chamber. In order to
work effectively and safely, some precautions will need to be taken by the
operator.
A. In most applications, the exhaust damper will need to be opened during
drying or degassing for best results.
B. THIS OVEN IS NOT DESIGNED TO HANDLE COMBUSTIBLE GASSES
AND IS NOT AN EXPLOSION PROOF UNIT. Do not place explosive,
combustible, or flammable materials into the chamber.
C. Some of the out gassed by products may be hazardous or unpleasant to
operating personnel. If this is the case, the exhausts should be positively
ventilated to the outside and dealt with according to local regulations. Your
dealer can provide you with a power exhaust which greatly helps under
these applications.
4.3 Do not operate near noxious fumes.
4.4 Do not place sealed or filled containers in the oven chamber.
4.5 Do not cut or remove the ground prong from the power cord.
4.6 Do not use a 2-prong adapter plug.
4.7 Be sure that the power supply is of the same voltage as specified.
4.8 Disconnect the unit from its electrical source before proceeding to make any
electrical repairs or replacements.
4.9 If a mercury thermometer is used for calibration and breakage should occur, all
spilled mercury MUST be completely removed from the chamber before continuing
operation.
4.10 This oven is NOT designed for the use in Class I, II, or III locations as defined by
the National Electric Code.
4.11 This oven is not intended, nor can it be used, as a patient connected device.
Section
4