Coleman Tent 9277B151 - Manual (Page 2)

THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Do not leave your tent set-up for weeks at a time, be aware that expo-
sure to the ultraviolet rays of the sun can seriously damage material and/or
cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammabili-
ty requirements of CPAI-84. The fabric may burn if left in continuous
contact with any flame source. The application of any foreign sub-
stance to the tent fabric may render the flame-resistant properties
ineffective.
Attach Tent to Frame
Using Frame Clips
–Attach frame clips along
the edges of tent to frame poles.
(illus. 6), (illus. 7)
–Make any adjustments to the tent
corner stakes that are needed.
3
4 Attach Rainfly
–Assemble rainfly pole by
interlocking shock-corded pole.
–Insert rainfly pole through pole
sleeve at the center of the front
curved edge on the underside of
rainfly. (illus. 8), (illus. 10)
–Drape rainfly over tent frame, pole
side down. Rainfly pole should be over
front door.
–Connect the eight elastic loops with
hooks, (found at the rainfly corners)
to the eight fabric loops on the bottom
row of frame clips. (illus. 9), (illus. 10)
–Insert the tips of the rainfly poles
into the grommets on the front
of tent. (See above illus. 7)
–Secure rainfly with attachments
located on underside of fly.
(illus. 9)
–Attach and stake out 4 guy lines
at the front and rear of tent.
illus. 7
Assembled tent without rainfly.
NOTE:
Grommets
for rainfly
pole are on
frame clip
webbing
illus. 6
Frame clips
illus. 8 Insert rainfly
poles through the
pole sleeve on
underside of rainfly
illus. 10
Completed tent
with rainfly.
illus. 9
Underside of
rainfly attaches
to frame poles
Rainfly pole
in grommet
Rainfly hooks attach to fabric loops
on the corner frame clips (illus. 9)
Guy line
Hooks attaches
to fabric loop
PRINTED IN CHINA Rev. 10/06