SIG SAUER BLASER K95 - Manual (Page 12)

12
2. Disassembling the rifle
2.4 Reinserting breech block
Place the breech block with the
semicircular shaft bearing »W« on the
shaft at the bottom of the receiver and tilt
it backwards. Press the block release
button »A« beside the trigger and keep it
pressed
down. Now, the top lever can be pushed
all the way to the right (slightly further
than for opening the rifle). Hold the top
lever in this position, you may now re-
lease the locking button »A«. Press the
breech block down into the receiver at
the back and release the top lever.
If you tilt the breech block all the way to
the back during assembly (green dot on
the left is not visible any more), push the
top lever to the right again (without
pressing the block release button) and let
the block snap into its slightly tilted
position by pushing it slightly towards the
front. In this position, the rifle can be
closed
(green dot is visible).
A
W
K95 English 2001 6/8/01 2:40 PM Page 12