SIG SAUER P238-P938-TGL Trigger Guard Laser - Manual

PX38-tGL tRiGGeR GUaRD LaSeR
PX38-tGL tRiGGeR GUaRD LaSeR
ContentS
oWneR’S manUaL
The PX38-TGL Trigger Guard Laser for the P238 ® and P938 ™ Pistols is a compact, light-
weight red laser used for targeting. The PX38-TGL integrates pinpoint accuracy and rapid
target acquisition with intuitive operation in a form fi tting package that weights only 1.0 oz.
featUReS
• Ambidextrous on / off switches
• Compact form factor blends with the lines of the P238 and P938
• Convenient low profi le mounting
• Windage & elevation adjustments
1. PX38-TGL Trigger Guard Laser 2. Instructions 3. 3V CR1/3N Lithium Battery
4. 1.5 mm allen key (windage & elevation adjustment)
inStRUCtionS
On/Off Switch
Laser
Left side cover
Elevation
adjustment screw
Allen head cover screw
install battery
• Remove (2) allen head screws
(left side)
• Remove left side cover
• Position battery matching the positive
(+) and negative (-) terminals.
mounting on fi rearm
• Ensure fi rearm is empty and clear of all
ammunition
• Position laser assembly over trigger
guard as shown
• Replace left side cover & install (2) allen
head screws
operation
• momentarily depress on/off switch to
activate laser
• momentarily depress on/off switch to
turn off laser
• Switching operates from either side
Laser adjustment
• to adjust laser windage or elevation, use
allen key
• clockwise moves dot right/down
• counterclockwise moves dot left/up
Allen head cover screw
On/Off Switch
Laser
Elevation
adjustment screw
Battery
Compartment
Windage
adjustment screw