Central Hydraulics 66593 - Manual (Page 5)

Page 5 SKU 66593 For technical questions, please call 1-800-444-3353.
SpECiFiCATiONS
Maximum Lifting Capacity 10 Tons (20,000 lb.)
Minimum Lift Height 6-1/4"
Maximum Lift Height 22-1/8"
Net Weight 326.30 lbs
Jack Handle 36-1/4"L
Wheels and Casters All steel
uNpACKiNG
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
ASSEMBLY
Slip the bottom end of the Handle 1.
(1.5) into the opening of the Fork
Member (2.4) .
Put the Washer (1.6) onto Fastening
2.
Screw (1.7) and insert into threaded
hole in back of Fork Member.
Tighten Fastening Screw securely
3.
with an adjustable wrench (not in-
cluded).
OpERATiNG iNSTRuCTiONS
Read the ENTiRE iMpORTANT
SAFETY iNFORMATiON section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
Tool Set up
iMpORTANT: The Jack comes filled with
oil. But the hydraulic system must be
bled prior to initial use. (See Bleed-
ing Instructions Pg. 8.)
Make sure the vehicle is parked on a
1.
flat, level, solid, ground surface.
Turn off the vehicle’s engine. Place
2.
the vehicle’s transmission in “PARK”
(if automatic) or in it lowest gear (if
manual). Set the emergency brake.
Then chock the wheels that are not
being lifted.
Check to make sure the Saddle (7.1)
3.
is fully lowered. If not, move the
Handle Lever (1.4) to Position D.
(See Fig. 2.)
Once the Jack’s Lift Arm (7.6) is fully a.
lowered, move the Handle Lever
(1.4) to Position A. (See Fig. 2.)
Fig. 1
Foot Pedal (2.1)
Hinge Rivet
4. Pump the Foot Pedal (2.1) after
carefully positioning the Saddle (7.1)
under the vehicle manufacturer’s
recommended lifting point. (See
vehicle manufacturer’s manual for
location of lift points when lifting only