SilentKnight EVS-VCM - Manual

Document LS10067-001SK-E Rev A
ECN: 13-0146
EVS-VCM Voice Control Module
Installation Instructions
The EVS-VCM Voice Control Module is
contained within the Silent Knight EVS
Series panel enclosure. It provides a
supervised microphone for live
communication and an interface for the
Emergency Voice System.
Note: Installation and wiring of this device must be done in
accordance with NFPA 72 and local ordinances.
Compatibility
The EVS-VCM is compatible with the
IntelliKnight 5820XL-EVS. For programming
and addressing, refer to Installation manual
for 5820XL-EVS (PN LS10061-001SK-E).
Board Layout & Mounting
1. Open the cabinet door and the dead
front panel.
2. Remove AC power and disconnect the
backup batteries from the main control
panel.
Mount the EVS-VCM in the middle section
of the dead front on the six mounting studs.
See Figure 1.
Figure 1: Back View of EVS-VCM
Specifications
Standby Current: 60 mA
Alarm Current: 80 mA
Wiring to a FACP
See Figure 2 to properly wire the EVS-VCM
to the FACP SBUS.
Figure 2: Wiring the EVS-VCM to the FACP
SBUS Address
DIPs
Dead Front Panel
Mounting Holes
SBUS
VBUS
Audio
AUX
Input
AUX
Audio
Trigger
Supervised
Power
Limited
EVS-VCM