SilentKnight IP Communicator Modem Card - Manual

2UD Modem Card
Mounting Instructions
The mIP-2 and the IPDACT-2 products can be converted to a mIP-2UD or to an
IPDACT-2UD (respectively) by installing the 2UD Modem Card. This will provide full
Alarm Panel Upload/Download support over the IP network.
Figure 1. Adding the 2UD modem card to a mIP-2 or an IPDACT-2 module
WARNING! Before proceeding with the installation, make sure all power
(AC and DC) has been removed.
The installer should follow the steps described below:
1. Remove the plastic label/cover from the IPDACT-2 Module. If the module is a mIP-2
this step may not be required.
2. Remove the jumpers from A and B pins located in the upper left portion of the mIP-2
or the IPDACT-2 module.
Dm395-Iv1 1