SilentKnight RBB Battery Accessory Cabinet - Manual

P/N 151306
RBB Accessory Cabinet
Installation Instructions
The RBB is an accessory cabinet that can be
used if your main control panel backup batteries
are too large to fit into the main control panel
cabinet.
Specifications
Installing the RBB
To properly install the accessory cabinet and
backup batteries, follow these steps:
1. Mount the accessory cabinet. See figure
Figure 1 for the four cabinet mounting holes.
• If mounting onto drywall the accessory
cabinet must be mounted onto 3/4-inch ply-
wood. This is necessary because the weight
of the batteries inside the accessory cabinet
could cause the cabinet to pull away from
the drywall.
• When mounting on concrete, especially
when moisture is expected, attach a piece
of 3/4-inch plywood to the concrete surface
and then attach the RBB cabinet to the ply-
wood.
• If using the battery cable extenders pro-
vided (P/N 140643), mount the RBB cabi-
net no more than 18" away from the main
control panel cabinet. This will ensure that
the battery cables reach the battery termi-
nals.
Figure 1: RBB Cabinet Mounting Holes
2. Connect the main control panel battery
cables to the battery cable extenders as
shown in Figure 2.
Figure 2: Splicing Control panel Battery Cables
3. Run extended battery cable from control
panel cabinet through conduit to RBB
cabinet. See Figure 3.
Figure 3: Battery Connections in the RBB Cabinet
Note: Figure 3 is an example of how the wire connections can
be routed. However, any other cabinet knock-outs (on
either the main control panel or the RBB cabinet), that
are not previously being used may be utilized to connect
conduit between the two cabinets.
Mounting: Surface
Cabinet Dimensions:
16”W x 10”H x 6”D
(406 mm W x 254 mm H x 152 mm D)
Cabinet Storage: Holds up to two batteries, each with
maximum dimensions as follows–
7.70”W x 8”H x 5.5”D
(196 mm W x 203 mm H x 140 mm D)
Cabinet
Mounting Holes
+ + - -
RBB Cabinet
Cover Screws
RBB Cabinet
Cover Screws