Slant/Fin F Series - Manual (Page 4)

SLANT/FIN CORPORATION, Greenvale, N.Y. 11548 • Phone: (516) 484-2600
FAX: (516) 484-5921 • Canada: Slant/Fin LTD/LTEE , Mississauga, Ontario
www.slantfin.com
©Slant/Fin Corp. 2009 Printed in the U.S.A. 909 Publication No. CP-40
INTERNAL SPLICE PLATE INSTALLATION INSTRUCTIONS
Cover sections may be tightly joined with internal splice plates for a neat, trim fit. They may be used instead of external splice plates.
Step 1:
After installing support brackets on the
wall at the desired height, place the cover
over the brackets and snap in place. Step 2:
Insert the internal splice plate just shy of
the halfway slots. Slots must remain
visible and not slide under cover. Step 3:
Insert screws, nails or slotted screw drivers into
the 2 halfway slots of the internal splice plate to
hold it in the correct location and prevent the
halfway slots from sliding under cover.
Step 4:
Place the next cover in place on support
brackets. Step 5:
Slide the next cover over the internal
splice plate up to the screws, nails or
slotted screw drivers. Step 6:
Remove the 2 screws, nails or screw
drivers.
Step 7:
Continue sliding cover sections together
until a snug fit is obtained.
Note: Product shown is unpainted and
does not represent finished installation.