SmarTek Systems SAS-1 Unpacking SAS Monitor Installation - Manual (Page 3)

SmarTek Systems (www.smarteksys.com) 3
Unpack Contents of Shipment
Each SAS-1 System comes fully assembled and configured according to selected options at the
time the order was placed. All electronic hardware necessary for installation is included. SAS-1
ships with a short home run cable (20 to 50 ft) as specified at the time the order was placed.
Inspect the shipping container for any signs of damage. If the contents are incomplete or if there
appears to be damage, notify SmarTek Systems.
Install SAS Monitor and Setup
The SAS Monitor and Setup software provided by SmarTek Systems is used to setup each
SAS-1 unit and to monitor operation to verify SAS-1 settings and performance. The SAS
Monitor and Setup software is designed to run on a Windows PC. For portability, a laptop PC
works well. The SAS Monitor and Setup software is provided on a CD and is installed by
clicking Start/Run. In the Run dialog window, click the Browse button. Click the down arrow
in the “Look In” text box at the top of the Browse dialog window. Click the CD identified as
“SmarTekApps”. Double click the Setup_Files folder and then double click the OneFile
folder. Click the Setupex.exe file and the click the Open button. Click OK in the Run dialog
window and follow the on-screen instructions. Use all default settings and folders if possible.
Figure 1 SAS-1 Bench Top Quick Checkout
SAS-1
SAS-CT
Short HR Cable
PC
PC to CT
RS-232 Cable
12VDC Battery
1 12
Short HR
Cable
Twisted Pair
1 - Gnd (NC)
2 -
TxD+ (Blue)
3 - TxD- (Blk of Blue)
4 -
RxD+ (Green)
5 - RxD- (Blk of Grn)
6 - RTS (NC)
7 - CTS (NC)
8 - Aux+ (NC)
9 - Aux- (NC)
10 - Gnd (Blk of Red)
11 -
PWR (Red)
12 - Gnd (Shield)
To PC
Terminal Block Connector
1
SAS Cabinet Termination
(SAS-CT)
(8 - 24 VDC)
+
RJ-45
-
12
To PC
Fuse