Snazzy FX TIDAL WAVE - Manual (Page 3)

!
!
!
!
!
!
!
!
Installation:
The Snazzy FX TIDALWAVE requires +/-12V to operate. It is
designed for use with the euro format modular synthesizer
system (please see)
http://www.doepfer.de/a100_man/
a100t_e.htm .
To install in your system, find space in your euro-rack
synthesizer system, plug the 16pin power cable into the
euro- rack style power distribution board, checking the
polarity so the RED STRIPE stripe on the cable is oriented to
the NEGATIVE 12 volt supply line. (LOOK FOR TEXT WHICH
SAYS NEG or -v or -12)
This is USUALLY at the bottom.
Please refer to your case manufacturers' specifications for
location of the negative supply.
!
IF IN ANY DOUBT PLEASE CONTACT YOUR DEALER!
or SNAZZY FX CONTACT [email protected]
REMEMBER..YOUR EURO DEALER IS THERE TO HELP YOU!