Snazzy FX DREAMBOAT - Manual (Page 10)

-Using An Oscilloscope:
1. Choose which section you want to view, TOP or BOTTOM.
2. Connect that sections X/Y outputs to your scopes X/Y
inputs.
3. Set the levels for each channel on your scope.
4. Switch to X/Y mode.
When viewing the outputs from the Bottom Oscillator Section,
please engage PERSIST in your oscilloscopes display settings so
that you can view the attractor over time in X/Y mode. This is not
necessary with the Top Oscillator Section, as it runs at audio
rates.
-Using a Computer
1. Connect the X/Y output pair of your choice to a set of STEREO
INPUTS on your soundcard. THIS MAY NOT WORK WITH THE
BOTTOM OSCILLATOR SECTION depending on your soundcard
due to a blocking capacitor. However, the top section should
work with just about any soundcard.
2. Turn the input gain on your soundcard low enough to handle
the high output of the module.
3. Open up a dual channel oscilloscope program, scope plugin,
OR a PHASE METER. Both Pro-TOOLS and LOGIC have stereo
phase meters (usually under METERS or LEVEL METER). Phase
Meters are exactly like the X/Y mode on a scope without any
adjustments.