Solberg BBFT(Pg.3-8,9) - Manual (Page 10)

Solberg Manufacturing, Inc., 1151 Ardmore Itasca, IL 60143 USA
Ph: 630.773.1363 Fax: 630.773.0727 Email: [email protected] Web: www.solbergmfg.com
Page 10
3. Removing element for service/maintenance.
A. Carefully lift element off of housing base.
B. Clean sealing surfaces of housing base, top plate and element end caps
so that they are free of dirt or any other particulate.
*WARNING*
Failure to comply with these instructions
may result in system or equipment
contamination.
4. Securing Element.
A. Place new or cleaned element evenly on base plate. Be sure element
seats properly on base and there is no dirt or particulate present on
sealing surfaces, see figure C.3.1. With multiple element stacks place
elements in line with base element and ensure elements seat properly.
*WARNING*
Defective installation may cause system or
pump contamination. Use only genuine
Solberg replacement parts.
Figure C.3.2: Element with pre-filter and
gaskets. Figure C.3.1: Element sitting in
housing base.