Solberg BBF Assembly - Manual (Page 2)

2 “BBF” Series Blower Base Frame Assembly Instructions Rev.: 9105
SOLBERG
Frequently Asked Questions
Important Information to Know
Before You Start
1. Can I use a right hand drive blower?
The Solberg BBF best accepts left hand drive blowers. To minimize issues during
assembly, specify left hand drive blowers in the package design.
2. How can the BBF be adapted to work with small motor blower packages
needing larger sheaves?
Some smaller blower and motor packages using larger sheaves may require component
elevation to allow for proper operational clearance for sheaves and belts. This can be
accomplished by fabricating spacer bars or adding a sliding motor base to raise the motor
and/or blower appropriately. Solberg can quote & provide appropriate items upon
request.
3. What can be done if motor mounting holes don’t match bolts provided?
Motors smaller than 25 Horsepower may have 3/8” holes in the mounting base that are
too small for the 1/2" carriage bolts provided as part of the kit. We suggest the following
options to address the issue. Use a 3/8” (or appropriate size) bolt, wide flange flat
washers (Solberg offers), lock washer and nut assembly to attach the motor. Additionally,
some equipment may have cast mounting feet which are too thick for the standard bolts
provided; Solberg can provide longer bolts upon request.
4. How can clearance issues between the belt guard and filter silencer be
addressed?
Depending on your blower height, it may be necessary to use a nipple and/or coupling to
elevate the filter silencer to obtain proper clearance above the belt guard.
5. How is the blower connected to the BBF?
The BBF has a pipe stub connection extending from the base. A straight pipe nipple is
inserted into the blower discharge and a rubber sleeve/boot and clamps are used to seal
the connection. Refer to sections 2-5 of the instructions for more detail. Solberg offers
optional Boot Kits designed for the BBF Series. For more information on rubber
sleeve/boots or any other custom connection methods which may be required contact
Solberg or your representative.
6. Why do I have extra hardware?
We include additional bolts, nuts, etc. for different belt centers and tensioning
configurations.
Consult Solberg with any questions.
Phone: 630.773.1363, E-mail: [email protected]