Soniclean Digital Benchtop Ultrasonic Cleaners - Manual (Page 5)

10 Adjust down Power Level if required. Default is 100% maximum power. These
optimized basic settings will be retained so long as the unit is powered on.
11 Leave unit to complete the operation or press Stop to cancel.
12 Operate with the lid on where possible.
13 After cleaning, rinse parts using clean running water.
FOR HEATER MODELS
14 Follow steps 1-6 before switching on heater.
15 Press Heater On to change heater temperature using More or Less keys to
increase or decrease temperatures. Factory default is
50 O C. Place lid on the unit to
prevent heat loss and evaporation. Press Heater Off to switch off the heater.
16 The LED display blinks when the liquid reaches the set temperature.
17 Ensure that minimum liquid level is maintained to prevent heater shut down.
18 If the heater shuts down, top up liquid, press Heater On again.
ULTRASONIC PERFORMANCE
19 To ensure your unit is working effectively, a daily aluminum foil test is
recommended.
20 Soniclean recommends – 0.025mm thick aluminum foil. Thicker foil will not work.
For consistent results, use SONIC 1 (ARTG No 141350) detergent dilution 0.5%-3.0%
and fluid temperatures from 22
0 C – 40 0 C.
21 Sonic 1 detergent has been specially formulated by Soniclean to give the best results
for Soniclean machines. Be aware that certain chemicals or excessive amounts of
certain chemicals affect the performance or damage unit. Check with your supplier if in
doubt.
22 Soniclean now provides an Ultrasonic Performance Meter (UPM) Model Sonic-
200/250 which validates or takes the place of the foil test – Refer to Australian Standard
AS2773-2
23 Check Soniclean Web Site www.soniclean.com.au for further information and
updates for UPM and Foil Test.
Issue date: 190913-1