Soul Electronics SL150 - Manual (Page 8)

4. Plug the 1/8” (3.5mm) plug into the headphone jack.
5. Power Up your device.
6. Select the music or movie you wish to hear or view.
7. Slowly increase the volume level until you find the safe and appropriate listening level for you.
Caution
Use your headphones responsibly. Exposure to excessively loud noise can cause Noise Induced Hearing Loss (NIHL).
Never put headphones on when unit is at full volume as it may cause permanent damage.
In-Line Remote Control Function and Diagram
For Controlling Phone Fuvctions
1. Answer/Hang Up – During an incoming call press and release the center button (
•
) once to answer the call. Once you have completed your call press and
release the center button once again to hang up the phone.
2. Call Rejection – If you do not want to answer an incoming call, you can hold the center button for approximately two seconds. You will hear two beeps once
you release the button that indicates the call was rejected.
3. Call Waiting – During a call in progress, you may answer another incoming call by pressing the center button. This will place the existing call on hold
while you answer the incoming call. If you want to switch to the original call press the center button again. That will place the second caller on hold while
you go back to your original call. You may repeat again to go back to second caller.
4. Volume Control - When you want to increase the volume of your phone, press the up arrow ( ) on your in-line controller. Note: Make sure to increase
volume slowly to prevent damage to your hearing. When you want to decrease the volume on your phone, press the down arrow ( ) on your controller.
6