Harbor Freight Tools Central Hydraulics 95553 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. Item 69593/69642/95553
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Tool Set Up
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure
in the tool, and release the throttle and/or turn the switch to its off position before
performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURy:
Do not adjust or tamper with any control or component in a way not specifically explained within
this manual. Improper adjustment can result in tool failure or other serious hazards.
Before Use
1. Park vehicle on a flat, level, solid, surface
safely away from oncoming traffic.
2. Turn off the vehicle’s engine.
3. Place the vehicle’s transmission in “PARK” (if
automatic) or in its lowest gear (if manual).
Set the vehicle’s emergency brake.
4. Chock the wheels that are not being lifted.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach
the work area without creating a tripping hazard
or exposing the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.