Soundmatters foxL DASH Manual - Manual (Page 3)

Turn the power OFF when not listening, to avoid battery drain. (Or in battery-operated Bluetooth
mode, set to Auto Off. See below.)
Your foxL DASH a plays less loud during the last 10% of its battery charge. Plug it in to restore
volume and charge up!
The foxL DASH a was acoustically engineered with patented fifth generation Twoofers (tweeters that
also woof ) for extremely wide sound dispersion characteristics allowing it to lie flat and fire its sound
omnidirectionally (for movies/parties) or directed at the listener for more critical listening. Placing the
foxL DASH a on a solid surface (either flat or vertically) will increase bass and overall output.
Bluetooth P Bluetooth P Bluetooth P Bluetooth P Bluetooth Po o o o ow w w w wer Savings Mode er Savings Mode er Savings Mode er Savings Mode er Savings Mode
You can set your foxL DASH a to preserve power while you are listening in battery-powered
Bluetooth mode. Using this feature, the unit will power off after Bluetooth connectivity is lost for
more than five minutes, provided the audio cable or USB cable is not plugged in. To enable or dis-
able this feature, simultaneously press the Volume Up and Volume Down buttons. The LED flashes
green to show power savings enabled; it flashes red to show power saving disabled.
Connection Options Connection Options Connection Options Connection Options Connection Options
1. Connect from the audio output of your device to the audio in of the foxL DASH a using a 3.5mm
stereo cable (included).
Or
2. Connect via Bluetooth with your A2DP Bluetooth streaming device:
Your foxL DASH a comes out of the box ready to Bluetooth pair. After turning it on for the first time,
wait until the LED blinks YELLOW; the foxL DASH a is then discoverable and in pairing mode. After it
appears on your device's Bluetooth connection list, select “soundmatters”, and it will connect after
a few seconds. Once you are paired, the next time you power up your foxL DASH a it
will autoconnect
to your last paired device.
To pair to an additional device, turn ON your foxL DASH a, then press and hold the Power/Bluetooth
button for 5 seconds. Once the LED blinks YELLOW, it is discoverable on your new device’s Bluetooth
pairing list. Select “soundmatters” on your device’s Bluetooth list to connect.
Your foxL DASH a can connect to 1 device at a time. To connect to a different Bluetooth source, either
disable the original device’s Bluetooth, turn the original device off, move it out of range, or force pair
per step 2 above.
The foxL DASH a can store up to 8 Bluetooth device pairs. To clear its memory of pairs, make sure
the unit is ON and insert the end of a paper clip into the RESET hole on the unit's side. Press gently
until you feel the internal button engage, then remove the paper clip.
W W W W Wir ir ir ir ireless Hands-fr eless Hands-fr eless Hands-fr eless Hands-fr eless Hands-free Calls ee Calls ee Calls ee Calls ee Calls
If your Bluetooth device is also a telephone, you can use your foxL DASH a as a speakerphone:
1. To pick up an incoming call, press and release the Power / Bluetooth button.
2. To end the call, press and release the Power/Bluetooth button.
3. To reject an incoming call, press the Power/Bluetooth button for 3 seconds, then release.