Vermont Casting VM508K - Manual (Page 6)

6 50004825
VM508K / VM658K Assembly
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or
moving the grill is recommended.
Step 4: Attach Brace Support to Metal Corner Post
Parts Required:
(1) Brace Support Left
(1) Brace Support Right
(8) #10-24 x 3/8” Screws (50004268)
Step 5: Attach Door Upper Brace to the Front of the Unit
Figure 3
Attach brace support left to the top of the
metal corner post.
Attach brace support right to the top of the
metal corner post.
NOTE: Be sure to attach the brace sup-
ports to the correct side. Refer to Figure 3.
NOTE: Do not tighten all screws at this
point.
Parts Required:
(1) Door Upper Brace
(w/ two (2) magnets already attached)
(4) #10-24 x 3/8” Screws (50004268)
NOTE: Remove protective layer from door up-
per brace.
Figure 4
Attach brace fascia to the front of the unit.
Make sure the brace fascia and front of the
metal corner posts are flush.
NOTE: Do not tighten all screws at this point.
����
�������������������
����
Door Upper Brace
#10-24 x 3/8”
Screws
(50004268)
B144
Figure 4
����
��������������������
����
Brace Support
Right
#10-24 x 3/8” Screws
(50004268)
B143
Figure 3
Brace
Support Left
Rear
Front
Front