Speeco S401622BL User Manual

Page 6

Advertising
background image

ALWAYS block the wheels to prevent movement of the log splitter while in operation.

KNOW how to stop the log splitter and disengage the controls before operating it.

NEVER place hands or feet between the log and splitting wedge during forward or reverse stroke as this could result in

serious injury or death.

NEVER straddle or step over the log splitter during operation.

NEVER reach or bend over the log splitter to pick up a log.

NEVER try to split two logs on top of each other.

NEVER try to cross split a log.

NEVER attempt to load the log splitter when the ram or wedge is in motion.

NEVER use your foot, a rope or any extension device to operate the control lever on the valve. Only use hand.

NEVER move the log splitter while the engine is running. Shut off the engine if you are leaving the log splitter, even for a

short period of time.

NEVER touch the muffler and other hot areas of the engine during operation. Wait until the engine cools down.

GENERAL REPAIR

NEVER operate your log splitter when it is in poor mechanical condition or in need of repair.

NEVER alter your log splitter in any manner. Such alterations may cause your log splitter to be unsafe and will void the

warranty.

NEVER tamper with the engine to run it at excessive speeds. The maximum engine speed is preset by the manufacturer

and is within safety limits. Refer to the engine owner’s manual for your particular log splitter.

NEVER perform any service or repair on your log splitter without first removing the spark plug wire.

ALWAYS perform all recommended maintenance procedures before using your log splitter.

ALWAYS check the level of hydraulic oil and engine oil before operation.

ALWAYS periodically check that all nuts, bolts, screws, hydraulic fittings and hose clamps are tight.

ALWAYS replace all damaged or worn parts immediately.

ALWAYS be sure that all replacement parts meet manufacturer’s specifications.

Page 4

Advertising